CANOGA PERKINS L357 Gigabit Ethernet Service Unit - Manual (Page 22)

EdgeAccess Universal Chassis System
L357 Gigabit Ethernet Service Unit 4-2
4.3 Management User Interface
The Management User Interface for the L357 provides screens for setup, monitoring, and diagnostics.
You can access the screens directly by connecting to the serial port of the BAM, the Model 1020, the
DMM in the chassis, or by establishing a Telnet session with the DMM. For details, see the Model
1500 Domain Management Module User Manual (for UCS 1000) or Model 1502 Domain
Management Module User Manual (for UCS 1002).
These sections discuss the screens for the L357, using a Telnet session for access.
4.3.1 General Screen Format
A typical screen, shown in Figure 9, includes standard descriptions and reference designations. Use
this and other screens to configure the system, set operational parameters, and verify the system
status. All screens use a common method for navigation.
Messages and
urgent status
Screen navigation
instructions
Change options
Status reports
Model number
Chassis and slot numbers
Figure 9. General Screen Format
Not all screens and menus provide options that you can change. Some menu items reach screens that
only report status, such as revision numbers, module type, or alarms. On other screens, you can move
through and select options, and enter data.
Use these keys to navigate the screens:
• Space bar When a menu item is highlighted, press <Space> to cycle through all options for that
item.
• Tab Press <Tab> to move the highlight to the next column to the right.
• Enter Press <Enter> to select the highlighted option for a menu item.
• Escape Press <Esc> to return to the previous screen.