CANOGA PERKINS L357 Gigabit Ethernet Service Unit - Manual (Page 42)

EdgeAccess Universal Chassis System
L357 Gigabit Ethernet Service Unit 4-22
Item Definition
5) Modem/Slip/PPP Baud Rate Select the baud rate, 9600, 19200, 38400, 57600, or
115200 bps for the modem/SLIP/PPP serial port (standalone
enclosure, only)
6) Modem Initialization String The default string is "
AT
" (standalone enclosure, only)
7) PING Generation Access the PING diagnostics screen (standalone enclosure,
only)
8) Static ARP Table Set or change specific IP and MAC addresses (standalone
enclosure, only)
9) Dynamic ARP Table View current IP and MAC addresses (standalone enclosure,
only)
4.11.1 PING Generation
Use the PING Generation screen to test the connection to a specific IP address. See Figure 35.
PING Generation
IP Address to PING: 0.0.0.0
PING count (1 to 255, 0 = forever):
0
Figure 35. PING Generation Screen
To use PING to check a connection, follow these steps:
1. From the Main Menu, type
7
, "Utilities," and press <Enter>.
1. From the Utilities menu, type
7
, "PING Generation," and press <Enter>.
2. At the PING menu prompt, set the PING parameters, and press <Enter>.
"
PING response received...
" indicates a good connection;
"
TIMEOUT: Unable to reach [IP address]...
" indicates a faulty connection.
3. To stop the PING , press <Esc>.