CANOGA PERKINS 9161 Network Interface Device - Manual (Page 27)

9161 Network Interface Device 3-13
2. At the Host Access Table screen, type 2 to add a host, then at the prompt, enter the host IP
address and mask, or type 1 to edit a host. At the Add Host Access Entry screen, set values for
these parameters:
• Telnet Access: Allow (Yes) or disallow (No) Telnet
• FTP/TFTP: Select FTP, TFTP, Both, or None
• SNMP Access: Select Write (also allows Read access), Write, or None
• SNMP Protocol: Select V1V2cV3, V1V2c, or V3
• V1/V2c Read and Write Communities: Enter name of community, up to 11 characters
• V1/V2c Access Level: Select Supervisor, Operator, or Observer
3. To remove a host, type 3 , then follow the prompts.
4. To return to the System Menu, press <Esc>.
Manage Traps and Alarms
Traps are messages that require management attention and are routed to the Network Manager and the
9161 Traps Log, but do not trigger alarms. Use the Trap Configuration screen to view the current
configuration and to enable or disable traps for the 9161. For a list of events that trigger traps, see
Table Error! Reference source not found.. To set up the traps, follow these steps:
1. From the System menu type 9 , "Trap Configuration," and press <Enter>.
2. At the Trap Configuration screen, type the number for a trap, then press <Space> to cycle
between Enabled or Disabled and press <Enter>
3. To return to the System menu, press <Esc>.
These selections do not affect how the Major and Minor LEDs report alarms.
Table 4. Trap Configuration Options
Trap When enabled, sends a Trap if. . .
Cold Start The 9161 is reset by a power failure or forced reset
Link Loss Forwarding A port loses a received link and transmits notification to the next port
Remote Fault Received A port receives an RMTF
Monitor System RMON, internal temperature, or a power supply is out of range or the fan failed
Monitor Port Module A port module is inserted or removed
VLAN Settings A user tries to delete the default or all VLANs
Link Up/Down The link went down and came back up
Authentication An unauthorized host attempts SNMP access
Spanning Tree An STP change occurs