CANOGA PERKINS 9161 Network Interface Device - Manual (Page 36)

9161 Network Interface Device 3-22
Check and Update Port Information
The Port Information screen shows the current conditions for all ports in the 9161 with options to
view parameters and statistics for specific ports. Configuration information includes the model
number, description, and revision, the serial number, and link, remote fault, and physical status. To
access the Port Information screen, follow these steps:
1. From the Main menu, type 3, "Port Information," and press <Enter>.
2. To view general information about a group of ports, type 1, "View Module," and press <Space>
to cycle through the groups of ports, then press <Enter>.
3. To view current status and set values for parameters for a selected port, type 2, "Port
Config/Status," then type the port name and press <Enter>. You can set values for these
parameters:
• Admin Mode: enable or disable
• Flow Control: enable or disable
• Link Trap: enable or disable
• Physical Mode: AutoNeg or any combination of 10 or 100 MHz and half or full duplex
• LACP Mode: enable or disable
• Network LED: on or off
• Remote Fault: enable or disable
4. To view current statistics for traffic through a selected port, type 3, "Port Statistics," then type the
port name and press <Enter>.
5. To return to the Main Menu, type 3.
Set Up Spanning Tree Parameters
Use the Global Spanning Tree Parameters menu to set various STP parameters for the 9161 within the
network. To access the Global Spanning Tree Parameters menu, follow these steps:
1. From the Switch Configuration menu, type 1, "Global Spanning Tree Parameters," and press
<Enter>.