CANOGA PERKINS 9171 Configuration Guide - Manual (Page 122)

CanogaOS Configuration Guide
19-2
Command Description
route-map abc redistribute command in OSPF.
DUT(config-router)# end Exit the OSPF mode and return to the
privileged EXEC mode.
Validation Commands
To display the route-map configuration, use the show route-map [NAME] in the
privileged EXEC command.
DUT# show route-map
route-map abc, permit, sequence 10
Match clauses:
metric 20
Set clauses:
tag 2
route-map abc, permit, sequence 20
Match clauses:
Set clauses:
19.3 Configuring the route-map and applying to BGP
Beginning in privileged EXEC mode, follow these steps to configure the route-map:
Command Description
DUT1# configure terminal Enter the Configure mode.
DUT1(config)# ip access-list acl1 Create an access-list named acl1.
DUT(config-ip-acl)# permit any any
3.3.3.0 0.0.0.255 Create a rule to permit the route with
3.3.3.0/24
DUT1(config-ip-acl)# exit Exit the access-list configure mode and return
to configure mode.
DUT1(config)# route-map abc
permit Create a route-map named abc and enter
route-map mode.
DUT1(config-route-map)# match ip
address acl1 Configure the match criteria.
DUT1(config-route-map)# set
local-preference 200 Configure the set action to be performed;
DUT1(config-route-map)# exit Exit route-map mode and return to configure
mode.
DUT1(config)# route-map abc
permit 20 Configure to add a route-map with the same
tag to match everything when the match
conditions above are not met. This is used to
prevent routes to be denied when not match
the match criteria above.
DUT1(config-route-map)# exit Exit route-map mode and return to configure
mode.
DUT1(config)# router bgp 1 Enter BGP router mode.
DUT1(config-router)# neighbor
1.1.1.2 remote-as 1 Configure the remote peer with neighbor
address 1.1.1.2 and remote-as 1.