CANOGA PERKINS 9171 Configuration Guide - Manual (Page 123)

CanogaOS Configuration Guide
19-3
Command Description
DUT1(config-router)# neighbor
1.1.1.2 route-map abc out Configure to apply the route-map abc to
outbound routes.
DUT1(config-router)# network
2.2.2.2/32 Configure to network the route 2.2.2.2/32
DUT1(config-router)# network
3.3.3.3/32 Configure to network the route 3.3.3.3/32
DUT(config-router)# end Exit the BGP mode and return to the
privileged EXEC mode.
Validation Commands
To display the route-map configuration, use the show route-map [NAME] in the
privileged EXEC command on DUT1.
DUT1# show route-map
route-map abc, permit, sequence 10
Match clauses:
ip address acl1
Set clauses:
local-preference 200
route-map abc, permit, sequence 20
Match clauses:
Set clauses:
Use the show ip bgp command to show the routes in BGP on DUT2.
DUT2# show ip bgp
BGP table version is 6, local router ID is 1.1.1.2
Status codes: s suppressed, d damped, h history, * valid, > best, i - internal,
S Stale
Origin codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPrf Weight Path
*>i2.2.2.2/32 1.1.1.1 0 100 0 i
*>i3.3.3.3/32 1.1.1.1 0 200 0 i