CANOGA PERKINS 9171 Configuration Guide - Manual (Page 201)

CanogaOS Configuration Guide
30-8
DUT1# ping mpls l2-circuit 100 source 10.10.10.10
Sending 5 MPLS Echos to VC Id : 100, timeout is 5 seconds
Codes:
'!' - Success, 'Q' - request not sent, '.' - timeout,
'x' - Retcode 0, 'M' - Malformed Request, 'm' - Errored TLV,
'D' - DS Mismatch,'F' No FEC Found,
'U' - Unknown Interface, 'R' - Transit (LBL Switched),
Type 'Ctrl+C' to abort
! seq_num = 1 4.4.4.2 963.53 ms
! seq_num = 2 4.4.4.2 929.87 ms
! seq_num = 3 4.4.4.2 1139.07 ms
! seq_num = 4 4.4.4.2 1567.48 ms
! seq_num = 5 4.4.4.2 968.81 ms
DUT1# traceroute mpls l2-circuit 100 source 10.10.10.10 detail
Tracing MPLS Label Switched Path to VC Id : 100, timeout is 5 seconds
Codes:
'!' - Success, 'Q' - request not sent, '.' - timeout,
'x' - Retcode 0, 'M' - Malformed Request, 'm' - Errored TLV,
'D' - DS Mismatch,'F' No FEC Found,
'U' - Unknown Interface, 'R' - Transit (LBL Switched),
Type 'Ctrl+C' to abort
0 2.2.2.1 MTU 1500 [Labels: 1024/ 1026]
R 1 2.2.2.2 MTU 1500 [Labels: 1027] 610.20 ms
R 2 3.3.3.2 MTU 9182 [Labels: implicit-null] 635.11 ms
! 3 4.4.4.2 1144.80 ms
30.4 Validating Layer 3 FEC
30.4.1 Configurations on PE1
Command Description
DUT1#configure terminal Enter the Configure mode.
DUT1(config)# interface eth-0-12 Enter the Interface mode.
• eth-0-12—Specify the interface
DUT1(config-if)# no switchport Configure the port to layer 3 port.
DUT1(config-if)# enable-ldp Configure Interface for LDP
DUT1(config-if)# ip address 2.2.2.1/24 Create IP address on the port.
DUT1(config-if)# exit Exit the Interface mode.
DUT1(config)#interface loopback 0 Enter the Interface mode.
• loopback0—Specify the loopback interface
name.
DUT1(config-if)#ip address 10.10.10.10/32 Create loopback addresses on both PE routers. Use
a /32 host route for the loopback address.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)#ip vrf vpn1 Configure a VPN routing and forwarding(VRF)