Dynon Avionics EFIS-D100 Installation Guide User Manual
Efis-d100
Advertising
Table of contents
Document Outline
- 1. INTRODUCTION
- 2. WIRING OVERVIEW
- 3. INSTRUMENT INSTALLATION
- 4. EFIS CALIBRATION AND CONFIGURATION
- 5. DSAB CONFIGURATION
- 6. AUTOPILOT INSTALLATION AND CONFIGURATION
- Additional Information and Updates
- DSAB Firmware Compatibility
- Compass Calibration Critical For Certain AP Modes
- Autopilot System Electrical Installation
- Servo Mechanical Installation
- AP74 Mechanical Installation
- Firmware Upgrades Required For AP Functionality
- AP Servo Configuration
- CONFIGURATION OVERVIEW
- STEP 1 - CONFIGURE DSAB
- STEP 2 - SERVO CALIBRATION AND SERVO TEST
- STEP 3 - ROLL SERVO INITIAL SETUP
- STEP 4 – PITCH SERVO INITIAL SETUP
- STEP 5 – DISENGAGE/CWS BUTTON CONFIGURATION
- STEP 6 - AUDIO ALERTS CONFIGURATION
- STEP 7 – PREPARE FOR FLIGHT TEST ON CLEAR, VFR DAY
- STEP 8 – ROLL SERVO FLIGHT TUNING
- STEP 9 – PITCH SERVO FLIGHT TUNING
- STEP 10 – VERIFY OVERALL AP PERFORMANCE
- AP74 Configuration
- 7. APPENDIX
- Appendix A: Ongoing Maintenance and Troubleshooting
- Appendix B: Dynon OAT Probe Installation and Usage
- Appendix C: HS34 Installation and Configuration
- Appendix D: Dynon AOA/Pitot Installation and Calibration
- Appendix E: Encoder Serial-to-Gray Code Converter Installation
- Appendix F: Replacing the EFIS-D100 battery pack
- Appendix G: Weights
- Appendix H: EFIS-D100 Specifications