Dynon Avionics EMS-D10 Installation Guide - Manual (Page 51)

EMS Configuration
enter these values according to the ones printed on your manifold pressure sensor, provided by
GRT.
Oil Pressure
Select the alarm mode and the analog bar thresholds
as described in Alarm and Color Threshold
Configuration on page 5-2. If the oil pressure
transducer has been installed, set the DISPLAY
parameter to ON, otherwise, set it to OFF. Change
the SENSOR TYPE to the correct number using the
sensor type table.
Sensor
Type
Oil Pressure Sensor
Dynon P/N 100411-002 or
1 Rotax 912 pre-installed
(prior to mid-2008)
2 GRT HPS-01
3 Jabiru pre-installed
4
EMS-D10 Installation Guide 5-9
Rotax P/N 956413 (mid-
2008 and later
Sensor
Type
Oil Temperature
Select the alarm mode and the analog bar
thresholds as described in Alarm and Color
Threshold Configuration on page 5-2. If the
oil temperature sensor has been installed, set
the DISPLAY parameter to ON, otherwise,
set it to OFF. Change the SENSOR TYPE to
the correct number using the sensor type
table.
Oil Temp Sensor
1 Dynon P/N 100409-001
2 Dynon P/N 100409-000
3 GRT FT-LC-01
4 Rotax pre-installed
5 Jabiru pre-installed
6 Chevrolet LS7 pre-installed