Cisco 4490 - Manual (Page 64)

Chapter 3 Installing the Cisco Global Site Selector 4490
Removing or Replacing a Cisco Global Site Selector 4490
3-18
Cisco Global Site Selector 4490 Hardware Installation Guide
78-15755-01
To physically remove a GSS from your network:
1. Power down the GSS by pressing the power button on the front panel of the
GSS.
2. Disconnect the power cords and network cables.
3. Physically remove the chassis from the rack.
To physically replace a GSS, install the new GSS and configure it using the same
configuration parameters (such as IP address) that you used for the removed GSS.
Refer to the Cisco Global Site Selector Getting Started Guide for details.