Cisco 4490 - Manual (Page 80)

Appendix B Connecting a Modem to the GSS 4490 Console Port
Configuring a Modem
B-2
Cisco Global Site Selector 4490 Hardware Installation Guide
78-15755-02
Configuring a Modem
You must configure the modem before you can connect it to the GSS 4490. You
can connect the modem to a terminal or a PC using a terminal emulation program,
such as Hyperterminal. If you connect the modem to the COM port on a PC, you
need the following cable and connectors:
• RJ-45-to-RJ-45 rolled cable
• RJ-45-to-DB-25 modem adapter
• DB-9-to-RJ-45 terminal adapter
Figure B-1 shows the pin number assignments for the 9-pin, male D-shell console
port connector on the back of the GSS 4490. These pin number assignments
conform to the industry standard.
Figure B-1 Console Port Connector
Table B-1 connector pinouts for the GSS 4490 console port.
1 5
6 9
83193
Table B-1 Console Port Connector Pinouts
Pin Number Signal Name
1 DCD (Data Carrier Detect)
2 RD (Receive Data)
3 TD (Transmit Data)
4 DTR (Data Terminal Ready)
5 SG (Signal Ground)
6 DSR (Data Set Ready)
7 RTS (Request to Send)
8 CTS (Clear to Send)
9 RI (Ring Indicator)