Dynon Avionics DX15 - Manual (Page 27)

DX15 User Guide 4‐3
 A frequency is manually entered from the keypad.
 A frequency is received for more than two (2) seconds.
 A frequency is transmitted on for more than two (2) seconds.
 When Recently Used Frequencies mode is entered, the current
frequency is stored as the most recently used
Note: To use Recently Used Frequencies, the “Side Buttons Used for
Direct Squelch“ option must be set to OFF (factory default). See the
Advanced Settings section of this manual for details.
Advanced Tip: The Recently Used frequency being displayed can be
deleted from the Recently Used list by holding CLR for a few seconds.
Using Memory Channels
Memory Channels allow you to store commonly used frequencies for
easy recall.
STORING FREQUENCIES INTO MEMORY CHANNELS
 Exit any other mode by pushing the CLR button on the keypad.
 Select a frequency.
 Push and hold the MEM button for one to two (1‐2) seconds, until
MEM‐XX is displayed, where XX is the lowest numerical unused
Memory Channel location between 00‐99.
 MEM will flash to indicate you are in Memory Channel programming
mode.
 The first available Memory Channel is automatically selected. If a
different Memory Channel is desired: Press the ◄ and ► or the side
▲ and ▼ buttons to decrement or increment, respectively, the
Memory Channel that will be used to store the current frequency. Or,
use the numeric keypad to enter a two‐digit Memory Channel location
manually.