Dynon Avionics DX15 - Manual (Page 36)

Advanced Settings
5‐4 DX15 User Guide
 If message "BANK‐Y" is displayed, this behavior is ON. Memory
Channels are scanned in banks of 10 Memory Channels each.
 The message will clear after two seconds, followed by a beep. You can
then use your DX15 normally.
 To change between modes, repeat the procedure (repeated cycles
toggle between the two modes).
Option: Disable Transmit
Toggles whether or not the DX15 can transmit when Push‐to‐Talk is
pressed. Disabling the ability to transmit can be useful for when you do
not wish to ever transmit on the air band by accidentally pushing the
Push‐to‐Talk button.
To set:
 Turn power OFF.
 Push and hold the ▼ button.
 Turn power ON.
 If message "tx OFF" is displayed, transmitting is disabled.
 If message "tx on" is displayed, transmitting is enabled.
 The message will clear after two seconds, followed by a beep. You can
then use your DX15 normally.
 To change between modes, repeat the procedure (repeated cycles
toggle between the two modes).
Option: Stop Transmitting on Stuck Mic
Toggles an option that stops the radio from transmitting if a stuck Mic is
detected.
To set: