Getting started with the new survey equipment, Ski-pro (ski-pro-l1) post-processing software, Receiver hardware – Leica Geosystems GPS System 500 Equipment - User Manual User Manual
Page 11
11
GPS Equipment User Manual - 4.0.0en
Getting started with the new Survey equipment
Getting started with the new Survey equipment
Receiver Hardware
The software contains a comprehen-
sive Online Help System. This Help
System is intended to replace the
function of a printed manual. If
required you may print out the entire
help for use as a hard copy reference
manual.
As a first step in getting familiar with
the software read the booklet Getting
Started with SKI-Pro delivered with
the SKI-Pro software package.
SKI-Pro (SKI-Pro-L1) post-processing software
In most cases, the software will be
installed by the local Leica repre-
sentative and a short introductory
course will be given.
Should this not be the case, install
the software as follows:
1. Insert the CD-ROM into the CD
drive of your PC.
2. Select Install SKI-Pro from the
menu.
3. Follow the instructions given by the
installation shield.
In most cases, a short introduction in
the use of the Receiver and Terminal
will be provided by the local Leica
representative. If this is not the case
proceed as outlined in the following
section.
Alternatively refer to the Technical
Reference PDF-manual available on
the SKI-Pro Installation CD.