Leica Geosystems GPS System 500 Equipment - User Manual - Manual (Page 27)

27
GPS Equipment User Manual - 4.0.0en
Getting started with the new Survey equipment
Configure through OWI
The MC500 can be incorporated as
an OEM product into a range of
positioning systems by third parties.
For example the MC500 can be
incorporated into Port Control Sys-
tems, Hydrographic Survey systems
and general machine guidance
systems for Construction, Mining and
Agriculture. Leica uses the MC500
as a critical component of the Dozer
2000 Machine Guidance product.
The MC500 can be configured using
an interface protocol developed by
Leica called the Outside World
Interface (OWI).
Documentation on the OWI format
can be supplied on request.
Figure MG.03 shows a typical con-
figuration set up to enable configura-
tion of the MC500 via OWI.
Figure MG.03 MC500 GPS Receiver configured by OWI
Getting started with the new MC equipment