Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 153)

153
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en COGO
INPUT
Enter bearing, mangnetic
bearing resp. azimuth (if "Azimuth"
is selected in the configuration during
"Direc. Type:"
RCALL
Call up of a direction which has been
previously stored using the function
"Polar calculation".
Changing the direction
(as dialog box "Modify
Bearing", "Modify Azimuth")
Exit the program.
NorthEast
Enter magnetic bearing (First or
second straight lines)
If "Azimuth" is selected in the
configuration during "Direc.Type:",
then the azimuth of the first straight
line (or the second straight line) can
be entered.
Offset
Entering parallel displacement.
Only active if "YES" is entered in the
configuration during "Offset:"
Left = negative parallel offset
Right = positive parallel offset
Accept displayed values.
Determining the direction by
means of the function "Polar
calculation" (refer to chapter
"Inverse").
The following dialog box shows the
result of the bearing-bearing
intersection:
Point Id
Entering point number of the bearing-
bearing
East
Display of east coordinate
North
Display of north coordinate
Elevation
Entering height (optional)
Bearing-Bearing Intersection, continued
COGO\ Brg-Brg Results
Point Id : -----
East : 0.000 m
North : 0.000 m
Elevation : -----
CONT STORE STAKE
MC
QUIT