Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 215)

215
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Road+
Preparing for the example, continued
Press to stakeout the
centerline point at the
specified station (chainage).
Depending on your program
configuration, you may see the
coordinates of this centerline point, or
you may go directly to the
STAKEOUT program.
Allows you to take a
measurement and determine
the station (chainage) and offset of
that measurement. You may then use
the station (chainage) of that
measurement to stake out a cross
section point, if you desire.
Press to change between cut
and fill templates. "FillS" is
shown when a cut template is active,
"CutS" when a fill template is active.
Allows you to view the
active station
equations, if you specified a station
equation file when you started
Road+.
Allows you to "jump"
directly to the Begin
Station (Chainage) specified in the
configuration.
Allows you to "jump"
directly to the End
Station (Chainage) specified in the
configuration.
Allows you to place a
note in the Log File, if
one is activated in the configuration.
Sta?
to set the measured point into
the Station & Offset dialog.
(Not available until after a
measurement has been made, or a
point imported.)
From this dialog, you may make a
measurement and Road+ will
calculate the station (chainage) and
offset at the prism, or you may import
a point and calculate the station
(chainage) and offset of that point.
QUIT
Road+\Sta. & Offset Result
Point Id : -----
Station : -----
Element : -----
H Offset : ----- m
V Offset : ----- m
MC
CONT MEAS STORE IMPOR