R with a dss receiver, Audio/video connections – Panasonic PV-4611 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
r
With a DSS Receiver
You can:
1) Record and view any channel including
scrambled channels; channel selection
must be made at the DSS Receiver.
2) Program one channel for unattended
recording.
NOTE: The DSS receiver must be turned
off to view programs from a cabie
box or antenna. See the DSS
manual for details.
IN FROM
CABLE or
Antenna
IN FROM
Satellite Dish
OUT TO TV
VHF/UHF
‘DSS® is a registered trademark of DIRECTV, INC., a unit of GM Hughed Electronics.
Audio/Video Connections
If your TV has AUDIO IN and VIDEO IN terminals, you can connect your VCR to them to receive a higher quality
picture and sound. The antenna-VCR and VCR-TV connection is as shown.
Audio/Video Connections
IN FROM ANT
OUT TO TV
VHF/UHF
VIDEO IN
1
Connect the VIDEO OUT terminal on the VCR to the VIDEO IN terminal of your TV.
2
Connect the AUDIO OUT terminals on the VCR to the AUDIO IN terminals of your TV.
3
Set the VIDEO/TV selector of your TV (Monitor/Receiver) to “VIDEO.”
NOTE: To use your TV as a VCR monitor, set the VIDEO/TV selector on the TV (Monitor/Receiver) to “VIDEO."
Note to CATV system installer:
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC in USA (and to the
Canadian Electrical code in Canada) that provides guidelines for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.