Panasonic ULTRA-PRO MC-V150 - Manual (Page 17)

MmMmmimmmmBmDmmmEfm
1.
Unplug cord from wall outlet.
DO NOT drip water on cleaner.
2. Clean exterior using a clean, soft cloth that has been dipped in a solution of mild liquid
detergent and water and wrung dry. Wipe dry after cleaning.
3. To reduce static electricity and dust build-up, wipe outer surface of cleaner and attachments.
4.
Wash attachments in warm soapy water, rinse and air dry.
DO NOT clean in dishwasher or
clothes washer.
DO NOT USE ATTACHMENTS IF THEY ARE WET.
A
CAUnON
Attachments used in dirty areas, such as under a refrigerator, should not be used
on other surfaces until they are washed. They could leave
znarArs.
The hose located on the back of the vacuum cleaner carries the dirt from the nozzle
up to the dust bag. If the hose should become clogged:
1. Unplug the power cord from the outlet
before checking the airflow passages. Pull
open the suction inlet cover and check for
clogging in this area.
Hosa
Cover
(Suction inlet)
2. Disconnect any optional accessories that
may be in use and check them for clogging.
Plug in the vacuum cleaner and turn it on.
While running the vacuum cleaner with the
accessories disconnected, stretch the hose in
and out to remove the clog.
3. If the clog still exists, turn the vacuum
cleaner OFF and unplug the power cord. Turn
the vacuum cleaner over, exposing the under­
side. Remove the lower plate. Remove the
hose from the housing by lifting it straight up.
Inspect the hose end and dear it of any
obstructions. Reinstall the hose and lower
plate. See the REMOVING/ INSTALLING THE
LOWER PLATE section for detailed instruc­
tions.
- 1 7 -