Panasonic PV-7451 - Manual (Page 9)

With a DSS Receiver
You can:
1
)
Record and view any channel including
scrambled channels: channel selection
must be made at the DSS Receiver.
2 )
Program one channel for unattended
recording.
NOTE: Thé DSS receiver must be turned
off to view programs from a cable
box or antenna. See the DSS
manual for details.
IN FROM
CABLE or
Audio/Video Connections
If your TV has AUDIO IN and VIDEO IN terminals, you can connect
your VCR to them to receive a higher quality picture and sound. If
your TV is not stereo, you can connect a stereo amplifier to the VCR
to enjoy stereo sound.
1 Connect the VIDEO OUT terminal on the VCR to the VIDEO IN terminal of your TV.
2 Connect the “L” and “R” AUDIO OUT terminals on the VCR to the “L” and “R” AUDIO IN terminals of your TV.
3 Set the VIDEO/TV selector of your TV (Monitor/Receiver) to “VIDEO.”
NOTE: To use your TV as a VCR monitor, set the VIDEO/TV selector on the TV (Monitor/Receiver) to “VIDEO.”
Use the L Audio In jack for proper sound reproduction when connecting to a monaural TV.
Stereo Amplifier Connections
When you connect your VCR to a
Stereo Component System, you
can view the picture from the VCR
while enjoying stereo from your
audio system.
Connect the “L” and “R” AUDIO
OUT terminals on the VCR to the
“L" and “R" AUDIO IN terminals of
your stereo.
Note to CATV system installer:
This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC in USA (and to the
Canadian Electrical Code in Canada) that provides guidelines for proper grounding and. in particular, specifies that the cable
ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.