Programming the remote control – Panasonic TU-DST51 User Manual
Page 42
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
P
rogramming
the
R
emote
C
ontroi
Programming the Remote Control
The Universal Remote Control can be programmed to operate many manufacturers’
components using the component function buttons for VCR, DVD, AUX (RCVR, CD,
TAPE, CASSETTE DECK and LD), CBL, DTV, TV, or DBS. Follow the procedures for
programming your Remote Control with and without codes for the component.
Determine the manufacturer of the component and look in the table for the code.
Note:
Be careful to press ACTION in the middle of the button. If you do not press in the
middle of the button, the arrow buttons may be activated. This will interrupt your
programming.
Programming With Code
•
Confirm that the external component is plugged in and is turned on.
•
Turn the component off.
•
Press the ACTION and POWER button, together, for at least 5 seconds. All
mode buttons will flash, then let go of the buttons.
•
Press appropriate component button (VCR, CBL, etc.) on the Remote
Control. The pressed button will illuminate steadily. All other buttons will go
out.
•
Enter the 3-digit component code using the Remote Control numeric keypad
(0 “ 9 buttons). If a proper code was entered, the mode button will blink twice
and go out.
•
Press the Remote Control POWER button to test the component. If the
procedure was successful, the component will turn on.
If the component does not operate wttti the Remote Control,
repeal the procedure using another code. (Some brands have
multiple codes.)
If an incorrect code is entered, or if the procedure takes longer
than 30 seconds, the programming will fail.
Programming Without Code
This procedure searches all codes and is called the “sequence method”.
•
Confirm that the external component is plugged in and is turned on.
•
Turn the component off.
•
Press the ACTION and POWER button, together, for at least 5 seconds. All
mode buttons will flash, then let go of the button.
•
Press appropriate component button on the Remote Control. The pressed
button will illuminate. All other buttons will go out.
•
Press the ^ button to move forward to the next code. Press the ^ button to
move backward.
•
Press the Remote Control POWER button to test the component. If the
procedure was successful, the component will turn on.
Note:
Repeat the preceding two steps until the component code is found. It may take many attempts
before the correct code is found.
•
After the code is found, press the ACTION button to store the code.