Between ant. and vcr, Between vcr and tv, Case 1: twin lead cable only – Panasonic PV-V4520 User Manual
Page 5: Case 2: twin lead & coaxial cables, Case 3: two twin lead cables, Case 1 : screw & plug type terminal, Case 2: screw type terminal, Case 3: double screw type terminal, I case 4: complex tv terminal
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1
Between ANT. and VCR
2
Between VCR and TV
Case 1: Twin Lead Cable Only
To VCR Terminal
From Antenna
(Flat) Twin Lead
300 Ohm Cable
300-75 ohm
Transformer
(not supplied)
Case 2: Twin Lead & Coaxial Cables
=£S3
(Round) 75 Ohm
coaxial Cable
UHFA/HF Band Mixer
(not supplied)
To VCR Terminal
Case 3: Two Twin Lead Cables
UHFA/HF Band Mixer
(not supplied)
300-75 ohm
Transformer
(not supplied)
To VCR Terminal
If your TV has both post and plug-type
VHF terminals, the post connection is
recommended to minimize signal loss.
Case 1 : Screw & Plug Type Terminal
UHFA/HF Band
Separator
(not supplied)
=£S3
RF Coaxial Cable
Case 2: Screw Type Terminal
75-300 ohm
T ransformer
(not supplied)
UHF
Case 3: Double Screw Type Terminal
UHFA/HF Band
Separator
(not supplied)
VHF
UHF
I Case 4: Complex TV Terminal
TERMINALS ON BACK OF TV SET
Split out
ANT1
ANT2
Connect to one of the ANT terminals and
select the same antenna number on the TV.
Note to CABLE system installer:
This reminder is provided to call the CABLE system installer’s
attention to Article 820-40 of the NEC in USA (and to the Canadian
Electrical Code in Canada) that provides guidelines for proper
grounding and, in particular, specifies that the cable ground shall
be connected to the grounding system of the building, as close to
the point of cable entry as practical.
FCC Warning: /Vty unauthorized changes or modifications
to this equipment would void the user's authority to operate.