Panasonic WJ-SQ508 - Manual (Page 13)

HOW TO SET UP THE UNIT NUMBERS
Important
Before the actual installation and wiring of the system
components has been made, you are strongly recommended
to draw a complete system diagram to set up the Station
number, Unit number, position of the CH SELECT, signal
flow of the Data Clock and other necessary switches.
Keep this diagram and refer it when the more components
are installed to expand the system.
The Bay System in Advanced Application-3 will be used as
an example to explain the setting up the unit numbers. (See
page 25.}
• In this system, sixty-four (64) cameras, five (5)
WV-CU300, twenty-four (24) WJ-SQ508 and four (4)
WJ-MP404 are used.
• Cameras No.1 to No.16 are observed by Satellite A,
Cameras No,17 to No.24 are observed by Satellite B,
Camera No.25 to No.64 are observed by Satellite C.
The Master Location & Sub Location observe the all
cameras and the Master Location has a primary control
right to the master-slave Sequential Switchers.
• The Unit Number Table on this page shows the full
loaded system with 64 cameras. 16 WJ-MP404, 24
WJ-SQ5O0, and 5 WV-CU300.
8 cameras (No.1 to No. 8 ) are being supplied to 2
WJ-MP404 (No.1 and No,2). These 2 WJ-MP404 are
connected with a WJ-SQ508 which has a station
number-1 with 8 video cables. These 8 video
signals are supplied to another WJ-SQ508 which
has a station number-3 by looping-through another
WJ-SQ508 which has station number-2.
The last 8 cameras (No.57 to No.64) are supplied to 2
WJ-MP404 (No.15 and No.16).
These 2 WJ-MP404 are connected with a WJ-SQ508
which has station number
-1 with 8 video cables.
These 8 video signals are supplied to another
WJ-SQ508 which has station number-3 by
loopeding-through another WJ-SQ508 which has
station number- 2 .
1) Compare the Unit Number Table with the Advanced
Application-3 on page 25.
2) Controller Unit Number
Assign a different controller unit number for each
WV-CU300 by using the Controller Number Selection
Switch (43).
3) Station Number
The station number of WJ-SQ508 is assigned as
indicated in the following procedure.
• The WJ-SQ508 which are connected to the cameras
directly or to the WJ-MP404 should have station
number ' 1 '.
• The WJ-SQ508 which receive the looped-through
video signals from station number 1 should be assigned
the station number 2 .
Set the Station Number Selection Switch (41) to the
position 2 ,
• The station number "3* should be given to the other
WJ-SQ508 as shown in the table.
• The unit number for the WJ-SQ508 will be given in
sequence from No.1 to No .8 in the same station.
4) Set the Station Number Selection Switch (41) and
the SEQ Unit Number Selection Switch (42) on the
WV-CU300 to the same numbers as set on the master
unit WJ-SQ508.
5) Two(2) WJ-MP404 can be connected to one
WJ-SQ508 with eight video cables.
Give the same unit number to the two WJ-MP404 that
the WJ-SQ508 connected with,
6 ) The WJ-MP404 accepts only four (4) cameras,
therefore, the CH SELECT switch on the one
WJ-MP404 should be set to the 1-4CH position and the
other WJ-MP404 should be set to the 5-8CH position.
Remark:
The above example on setting up the unit numbers is
based on the maximum system installations.
Even though a particular system does not have the
maximum system installations, give the unit numbers
to the components as if the system did contain the
maximum system components. Also skip any unused
numbers as shown in the shaded numbers in the Unit
Number Table. This idea will be helpful for future
expansion of the system.
<Unit Number Table>
CAMERAS
CAMERA 1
CAMERA 2
CAMERA 3
CAMERA 4
CAMERA 5 ,
CAMERA 6
CAMERA 7
CAMERA 8
CAMERA e
CAMERA 10
CAMERA)1
CAMERA 13
CAMERA 13
CAMERA 14
CAMERA 15
CAMERA 16
CAMERA 17
CAMERA 13
CAMERA 1g
CAMERA 20
CAMERA 21
CAMERA 22
CAMERA 23
CAMERA 24
CAMERA 25
CAMERA 26
CAMERA 27
CAMERA 23
CAMERA 28
CAMERA 30
CAMERA 31
CAMERA 32
CAMERA 33
CAMERA 34
CAMERA 35
CAMERA 36
CAMERA 37
CAMERA 36
CAMERA 30
CAMERA 40
CAMERA 41
CAMERA 42
CAMERA 43
CAMERA 44
CAMERA 45
CAMERA 40
CAMERA 47
CAMERA 48
CAMERA 40
CAMERA SO
CAMERA 51
CAMERA 52
CAMERA 53
CAMERA 54
CAMERA 55
CAMERA 56
CAMERA 57
CAMERA 56
CAMERA 50
CAMERA 60
CAMERA 61
CAMERA 62
CAMERA 63
CAMERA 64
UNIT CH SELECT
1 - 1'--4CH
WJ-S0508 WJ-SQ506 WJ-SO508
I STATION'UNIT
(M)
_____ (S)_____ I
(Ml
JS)
I (M)
(S)
(M)
I___(S)_
STATION "UNIT
(M)
(S)
(M)
(S)
(M}
(S)
' 2
(M)
:___(s).
STATION "UNIT
(M)
(S)
(M)
(S)
(M)
t (S)
(M)
-(S).
WV-CU300 STATION NUMBER
- 1 2 -