Panasonic PV C923 - Manual (Page 10)

REMOTE CONTROL
iNSTALLATfON
open the battery compartment cover.
Install two “AAA’ batteries, paying attention to the polarity
tiiagram in the battery compartment.
Replace the compartment cover.
BATTERY PRECAUTIONS
The precautions below shoulrJ be followed when using
batteries in this device:
1 Use only the size and type of batteries specified.
2 Be sure to follow the correct polarity when Installing
the batteries as indicateri in the battery compartment.
Reversed batteries may cause damage to the device.
3 Do not mix different types of batteries together (e.g. Al­
kaline and Carbon-zinc) or old batteries with fresh ones.
4 If the rievice is not to be used for a long period of time,
remove the batteries to prevent damage or injury from
possible battery leakage.
5 Do not try to recharge batteries not intended to be
recharged; they can overheat and rupture (Follow
battery manufacturer’s directions).
NOTES:
10
When there is an obstacle between the TVA/CR
and the remote control, the remote control may
not operate.
When direct sunlight, an incandescent lamp,
fluorescent lamp or any other strong light
shines on the Remote sensor of the TV/VCR,
the remote operation may be unstable.
Use the AC polarized line cord provided for operation on
AC. Insert the AC cord plug into a standard 120V 60Hz
polarized AC outlet.
NOTES; * Never connect the AC line cord plug to
anything other than the specified voltage (120V
60Hz). Use the attached power cord only.
* If the polarized AC cord does not fit into a
nonpolarized AC outlet, do not attempt to fife
or cut the blade. It is the user's responsibility
to have an electrician replace the obsolete
outlet.
* If you cause a static discharge when touching
the unit, and the unit fails to function, simply
unplug the unit from the wall outlet, wait 10
minutes and plug it back In. The unit should
return to normal operation.
AC Outlet
(One blade is wider than the other.)
TO USE DC POWER
By using the DC car cord supplied with the TV/VCR, you
can operate this TV/VCR from a cigarette lighter socket
in any car that utilizes a negative ground system.
The fused 12V DC car cord has been designed to power
the set from the external DC power (12 volt negative
ground) through the TV/VCR DC input jack.
Connect the smaller plug on the end of the cord to the
DC input jack on the rear of the TV/VCR, then Insert the
other end of the car cord into the cigarette lighter socket
of your car. Make sure that the cord makes a firm
connection.
It may be necessary to try several insertions, rotating
the plug for proper electrical connection.
TV/VCR
CAR