Panasonic PV C923 - Manual (Page 14)

1 Press the MENU button.
Press the SET/TRACKING ^ or-
buSton to select the SYSTEM
SETUP option, then press the
ENTER button.
2 Press the SET/TRACKING + or-
button to select the CLOCK SET
option, then press the ENTER
button.
3 Press the SET/TRACKING + or-
button to set the month, IJien press
the ENTER buHon.
4 Set the day, year and time as In
step 3.
After setting the clock, date and time
starts functioning automatically.
TIMER SEC SET
TV SETUP
CH SETUP
■AUTOREPEAT ONKJFF
SYSTEM SETUP -t
<+WENT£R,'í/IÉNLt)
^ /SYSTEM ^TUP
-■CLOCK
^^LA^JGUAGDltíЗOI/WLA^OU£
■ AUTO CLOCK KIN OFF
i STANDARD TIME
I DAYLIGHT SA'/ING TIME
<+WENT£R,'í/IÉNLt)
MONTH -10-
DAY
' т ш У )
YEAR 2С1Й
TIME
12 00 AM
(♦/■^NTER/CANCEUMENU)
CLOCK ^T
MONTH
DAY
YEAR
T íme
1ÍI
8-30-AM
/ \
(+/-CNTER/CANCEUMÉNU)
TV OPERATION
You must set the date and time manually for Timer
Recordings, ON/OFF Timer and Daylight Saving Time
if the Auto Clock process did not set them correctly.
EXAMPLE; Setting the clock to “8;30 AM", 29th (WED)
October, 2003.
NOTES: * After a power failure or disconnection of the
power plug, the time display will be lost. In
this case, set the present time again if the
Auto Clock did not set correctly.
• To move cursor backward, press the CANCEL
button.
1 To turn on the TV/VCR, press the POWER button
2 Adjust the volume level by
pressing the VOL + or - button.
The volume level will be
indicated on the screen by
green bars. As the volume level
increases, so do the number of
bars. If the volume decreases, the number of green
bars also decreases.
3 Set the TV/CATV menu option to the appropriate
position (See page 16).
4 Press the Direct Channel selection buttons to select
the channel.
• TV mode direct channe! selection
When the TV/CATV menu option is in the TV
position, all channels can be instantly selected by
using two buttons {for example, to select channel 2,
press "0", then "2". If you press only "2", channel
selection will be delayed for a few seconds). For
channels 10 and above, press the 2 digits in order.
• CATV mode direct channel selection
When the TV/CATV menu option is in the CATV
position, channels can be selected as follows:
• TO SELECT CATV CHANNELS:
1-9 Press "0" twice, then 1-9 as needed.
Example, to select channel 2, press "002".
10-12 Press "0", then the remaining 2 digits.
Example, to select channel 12, press "012”.
13-99 Press the 2 digits In order.
Example, to select channel 36, press ”36”.
100-125 Press the 3 digits in order.
Example, to select channel 120, press "120".
NOTE FOR CHANNELS 1-12;
If only 1 or 2 buttons are pressed,
the corresponding channel will be
selected in 2 seconds.
NOTES: * If a channel with no broadcast is selected,
the sound will automatically be muted.
• If a station being viewed stops broadcasting,
the TV will automatically shut itself off after
15 minutes.
14