Panasonic PV-8665S - Manual (Page 16)

One Time VCR Setup
‘Important: U the remote control POWER, ACTION, PROG, CHA/T, INDEX or ADD/DLT button does
not work when pressed, press the VCR button on the remote and try the button again.
Alternate Instructions
Complete the following steps if, any of the following applies:
• You selected connection type 2 (VCR^CABLE/ DSS
BOX^TV or VCR^tV) in step 4 on page 14.
• You selected “NO REMOTE" in step 6 on page 14
(your cable box or DSS receiver is not remote
controllable).
• You use a DSS receiver and selected “YES” in step
8 on page 15.
1
Turn on the cable box and
set it to the local PBS channel.
• If you live near a different time
zone, make sure to set the
channel in your time zone.
• If you use a DSS receiver,
it must be turned off.
OWJNEL/CLOCK AUTO SET
CONNECT ANTENNA CABLE
ANO IF YOU USE A CABLE
BOX. TUNE IT TO YOUH
LOCAL PBS CH THEN, , .
PLEASE PUSH CH UP KEY
Press CH A* to start Channel Auto Set and
Auto Clock Set.
• The following messages appear.
“CH AUTO SET PROCEEDING"
“AUTO CLOCK SET PROCEEDING"
This screen appears to confirm that
auto clock set is completed.
3
Confirm that the time is
correct and press CH
A
to exit.
If this screen appears, auto
clock set is not available in
your area. Please set the clock
manually as described below.
1/ 4/2000 TUE 12:OOPH
DSTiON
SETTtNG : CH 02
AUTO aOCK SET
COMPLETED
END : PUSH CH UP KEY
AUTO aOCK SET
IS INCOMPLETE
PUSH ACTION TO SET CLOCK
-\4/—
A Press ACTION to display the
SET CLOCK screen.
B Press
AT
and ► to
select and set the month,
date, year, time, and
DST. (Daylight Saving Time).
To Make Corrections,
repeatedly press ► to move the cursor
to the incorrect entry and make the correction.
OST:ON
SB.ECT:A ▼ KEY
SET :► KEY
END lACTION KEY
C Press ACTION twice to start
the clock and exit this mode.
uae^ian.1
SET :-« ► KEY
START ¡ACTION KEY
If the displayed time and DST.
are not correct...
If you happen to live close to two time zones,
the VCR may have recognized the PBS
channel (setting channel) in the wrong time
zone. Please do the following to correct the
situation.
a Make a note of the SETTINGiCH number
shown on screen and press CH A to exit.
b Delete the setting channel from the VCR
channel memory. (See the “To Add or
Delete a Channel" section on page 17.)
c Press ACTION to display the menu.
d Press
AT
to select “SET CLOCK," and then
press ► to display the “SET CLOCK” screen.
e Press
AT
and ► to select and set “AUTO
CLOCK SET."
f Follow the One Time VCR Setup
instructions on pages 14-16.
• If you use a cable box and have multiple PBS
stations, tune the cable box to a different PBS
station and try auto clock set using the menu.
16