Yamaha pw80 - Manual (Page 38)

6. Remove the dial gauge and slide the con­
necting rod to one side. Insert a feeler
gauge between the side of the connec­
ting rod big end and the crank wheel.
Measure clearance.
Connecting rod/crank side clearance:
0.30-0.80 mm (0.012-0.031 in)
CLUTCH
7. If any of the above measurements exceed
tolerance, crankshaft repair is required.
Take the machine to your authorized
dealer.
8. During reassembly apply a liberal coating
of two-stroke oil to the piston pin and
bearing. Apply several drops of oil to the
connecting rod big end. Apply several
drops of oil into each crankshaft bearings
oil delivery hole.
Removal
1. Remove the kick starter.
2. Remove the pan head screws holding the
case cover in place and remove the cover.
Note the position of the dowel pins.
NOTE: ------------------------------------------
Drain transmission oil before removing cover.
ft
3. Using the Rotor Holder, remove the
clutch securing nut and lock washer. Re­
move the clutch boss and driven gear
(clutch housing).
-26-