Contemporary Research TD960801-0MC - Manual (Page 9)

TD960801-0MC
5
2
Installation
2.1 Introduction
The EXTEND-A-BUS series is intended to be panel mounted
into an industrial enclosure or into a wiring closet. Two #8 pan
head screws (not provided) are required for mounting.
Optionally, the bridge can be mounted on a DIN rail by
purchasing a DIN rail mounting kit.
2.2. Electromagnetic Compliance
The EXTEND-A-BUS series complies with Class A radiated
and conducted emissions as defined by FCC part 15 and
EN55022. This equipment is intended for use in non-residential
areas. Refer to the following notices in regard to the location of
the installed equipment.
Note: This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own
expense.
Warning
This is a Class A product as defined in EN55022. In a
domestic environment this product may cause radio
interference in which case the user may be required to take
adequate measures.