Panasonic CT-27D42 - Manual (Page 6)

I nstallation
1
Polarized plug
Installation
Television Location
Follow these recommendations before deciding the location of your Interactive television.
□ Avoid excessive sunlight or bright lights, including reflections.
□ Keep away from excessive heat or moisture. Inadequate ventilation may cause internal component failure.
O Fluorescent lighting may reduce remote control transmitting range.
G Keep away from magnetic equipment, including motors, fans and external speakers.
CAUTION: Use this television receiver oniy with the cart, stand, tripod, bracket, or table specified by the
manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus
combination to avoid injury from tip-over. In order to avoid injury to children, never place your television receiver
on a piece of furniture that is capable of being tilted by a child leaning on it, pulling on it. standing on it, or
climbing on it.
Optional Cable Connections
Shielded audio and video cables should be used between components. For best results:
G Use 75-ohm coaxial shielded cables.
G Use appropriate input and output connectors that match your component connectors.
G Avoid long cables to minimize interference.
AC Power Supply Cord
CAUTION: TO PREVENT ELECTRIC SHOCK MATCH WIDE BLADE OF PLUG TO WIDE SLOT OF AC OUTLET
AND FULLY INSERT. DO NOT USE A PLUG WITH A RECEPTACLE OR OTHER OUTLET UNLESS THE BLADE
CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
PROTECT POWER CORDS FROM BEING WALKED ON, ROLLED OVER, CRIMPED, BENT OR PINCHED, PARTICULARLY AT
PLUGS, CONVENIENCE RECEPTACLES. AND THE POINT WHERE THEY EXIT FROM THE APPARATUS.
Cable / Antenna Connection
For proper reception, either a cable or antenna connection is required.
Cable Connection
Connect the cable supplied by your local cable company.
Note: A cable converter box may be required for proper reception. Check with your local cable company for
compatibility requirements.
Antenna Connection
• For proper reception of VHF/UHF channels, an external antenna is required. For best reception, an
outdoor antenna is recommended.
» Connect home antenna to ANT on the back of television.
Note: Cable Mode is preset at the far^ory. Arrtenna users must change to TV mode in the Set Up Menu under
Prog Chan.
Battery Installation
Remote Control and Wireless Keyboard
Use two AA batteries:
Battery cover is located on back of keyboard and remote.
Remove battery cover.
Install batteries matching (+) and (-) polarity signs.
Replace the battery cover.
Note: Incorrect installation can cause battery leakage and corrosion that will damage the Remote Control or Wireless Keyboard.
Precautions
• Replace batteries in pairs.
• Do not mix battery t^s (zinc carixrn with alkaline).
• Do not recharge, heat, short-circuit, disassemble, or bum batteries.
Wireless Keyboard
Battery Cover
Incoming C^le from
Cable Company
He
75 Ohm VHF/UHF
on back of TV
incoming came from
Home Antenna