Getting started, Connecting to analog phone line, Located on back of set – Panasonic CT-27D42 User Manual
Page 8: Connecting wireless jack for modems, Connecting to an ethernet broadband source
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
G
etting
S
tarted
Getting Started
Connecting to Analog Phone Line
Plug in an analog phone line into the RJ-11C phone 4 conductor located in the rear panel of the receiver. This is the upper
rectangular jack located in the jack pack area on the back panel of the receiver.
Located On Back Of Set
Connecting Wireless Jack for Modems
If the phone jack is located to far from the receiver to make connections, use the pair of wireless modules that is packed in
the carton with the receiver. To install, refer to the manual part # TQB2AA0410 located in the carton.
Connecting to an Ethernet Broadband Source
Plug In cable connected to an Ethernet source to the RJ-45 8 conductor on the receiver on the back panel. This is the
rectangular connector just below the RJ-11 phone jack. Make sure the cable for the phone connection is not plugged into
the RJ-45 connector on the back panel for the Ethernet connection.
Located On Back Of Set
6
•