Microphone sensitivity selector – Panasonic NV-MC20 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Microphone Sensitivity Seiector
o—
©To temporarily stop the recording (recording pause), press the
Start/Stop Button again.
©To finish the recording, put the VHS-C Movie in the recording
pause mode and then slide the Operation On/Off Switch
to the right again to turn the VHS-C Movie oft.
•If the VHS-C Movie is left in the Record pause mode for more
than 6 minutes:
The VHS-C Movie will automatically switch over to the power off
mode to protect the tape and save battery power.
•When the tape reaches its end during recording, the VHS-C
Movie will automatically switch over to the stop mode.
Microphone Sensitivity Selector
The sensitivity of the Microphone can be increased by setting the
Microphone Sensitivity Selector to "HIGH”. Usually, this selector is
left in the "NORMAL" position.
•If this selector is switched from "HIGH” to "NORMAL" during
recording, the recording of the audio signal will be interrupted for
a few seconds. However, this is not due to any malfunction.
<16>