Panasonic PV-GS39 - Manual (Page 15)

i ii.- Fi/i- ( r:- i!; 1 ■=!
{!■'s’-o3b'i Oij.y :
Direct the Remote Control at the Remote
Control Sensor of the Camcorder and
press an appropriate button.
1
• Distance from the Camcorder: Within
approximately 15 feet (5 meters)
• Angle: Within approximately 15° in the vertical
and horizontal directions from the central axis
The above operating ranges are for indoor use.
Outdoors or under strong light, the Camcorder may
not operate properly even within the above ranges.
■ Selecting Remote Control Modes
When 2 Camcorders are used simultaneously,
they can be operated Individually by selecting
different Remote Control Modes.
• If the Remote Control Mode of the Camcorder
and that of the Remote Control do not match
with each other. [REMOTE] will appear. When
the Remote Control Is operated for the first
time after the Camcorder is turned on, [CHECK
REMOTE MODE] (p. 71) will appear and
operation is Impossible. Set the same Remote
Control Mode.
■ Setup on the Camcorder
Set [ ii REMOTE] on the [ ^ SETUP] Sub-Menu to
the desired Remote Control Mode. (pp. 27, 28)
I Setup on the Remote Control
[VCR1]:
Press the [!►] Button and [ ■ ] Button
simultaneously. O
[VCR2]:
Press the [-^1] Button and [ m ] Button
simultaneously. ©
• When the battery
In
the Remote Control is
replaced, the mode is automatically reset to [VCR1]
Mode.
di“ .AC 'j.-Jai,'!..!
Before connecting or disconnecting the
power supply, set the [OFF/ON] Switch on
the Camcorder to [OFF] and make sure that
[STATUS] Indicator is not lit. (p. 20)
o
S
c
S5.
to
1
Connect the DC Cable to the Camcorder.
2
Connect the DC Cable to the AC Adaptor.
3
Connect the AC Cable to the AC Adaptor
and the AC Jack.
tlic- Battery
Before use, Ally charge the Baitery.
• We recommend using a Panasonic Battery.
• We cannot guarantee the quality of this Camcorder
when batteries from other companies are used.
1
Attach the Battery to the AC Adaptor and
charge it.
2
Put the Battery on the Battery Mount by
aligning the mark, and then securely plug
it in.
15