Panasonic PV-GS39 User Manual

Page 72

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

CHANGE TO MANUAL MODE:

You are attempting to select an item other than

[OFF] In [n SCENE MODE] when the [AUTO/
MANUAL/FOCUS] Switch is set to [AUTO],

CAN NOT OPERATE

(MOTION DV MODE) (PV-GS59 Only):

You are attempting to change [O D.ZOOM]
setting during MotionDV Mode.

TURN OFF THE VIDEO LIGHT:

You are attempting to select an item in [ ¡[I
SCENE MODE] when Light Is on.

REVERSE THE LCD MONITOR:

When the LCD Monitor is rotated by 180°

towards the lens, the brightness of the LCD

Monitor cannot be adjusted.

* •

■ After Use

1

Take out the Cassette, (pp. 18~19)

2

Set the [OFF/ON] Switch to [OFF],

3

Take out the Card. (pp. 19~20)

4

Detach the power supply and retract the

Viewfinder or the LCD Monitor, (pp. 21-22)

5

To protect the Lens, attach the supplied

Lens Cap.

■ Cautions for Use

When you use your Camcorder on a rainy or

snowy day or on a beach, make sure that no

water enters the Camcorder.

• Water may cause the Camcorder or Cassette to

malfunction. (Irreparable failure may occur.)

• If sea water splashes onto the Camcorder, wet a

soft cloth with tap water, wring it well, and use it to

wipe the camera body carefully. Then, wipe it again
thoroughly with a soft dry doth.

Keep the Camcorder away from magnetized

equipment (such as a microwave oven, TV,
video game equipment, etc.).

• If you use the Camcorder on or near a TV, images

or sounds may be disturbed due to electromagnetic
wave radiation.

• Do not use near a cel! phone because doing so

may cause noise to adversely affect the picture and
sound.

• Recordings on the tape may be damaged, or

images may be distorted, by strong magnetic fields
created by speakers or large motors.

• Electromagnetic wave radiation generated by

a microprocessor may adversely affect the
Camcorder, causing the disturbance of images and
sounds.

• If the Camcorder is affected by magnetically

charged equipment and does not function properly,
turn off the Camcorder power and detach the

Battery or AC Adaptor and then connect the Battery

or AC Adaptor again. Thereafter, turn on the
Camcorder power.

Do not use your Camcorder near radio

transmitters

or

high-voltage

cables.

• If you record pictures near radio transmitters or

high-voltage cables, recorded images or sounds
may be adversely affected.

Do

not use this Camcorder for surveillance

purposes or other business use.
• If you use the Camcorder for a long period of

time, the internal temperature increases and,
consequently, this may cause malfunction.

• This Camcorder is not intended for business use.

When you

use

your Camcorder on a beach or

similar place, do not let sand or fine dust get

into the Camcorder.

• Sand or dust may damage the Camcorder or

Cassette. (Care should be taken when inserting
and removing the Cassette.)

Do not spray insecticides or volatile

chemicals onto the Camcorder.
• If the Camcorder is sprayed with such chemicals,

the camera body may be deformed and the surface

finish may pee! off.

• Do not keep rubber or plastic products in contact

with the Camcorder for a long period of time.

Do

not use benzine, thinner or

alcohol

for

cleaning the Camcorder.
• The Camcorder body may be deformed and the

surface finish may pee! off.

• Before cleaning, detach the Battery or pull out the

AC Cable from the AC Jack.

• Wipe the Camcorder with a soft dry doth. To

remove stubborn stains, wipe with a cloth that
is soaked in a detergent diluted with water and

aftenwards finish wiping with a dry cloth.

• For storing or transporting the Camcorder, place

It

in a bag or case lined with soft pads so as to

prevent the coating on the camera body from being

worn.

After use, be sure to take the Cassette

out

and

detach the Battery from the

Camcorder or

pull

out the AC Cable from AC Jack.
• If the Cassette is left in the Camcorder, the tape

sags and deteriorates.

• If the Battery is left on the Camcorder for a long

time, the voltage drops excessively, and the Battery

will not function even after it is recharged.

72

Advertising