Panasonic SC-CH31 - Manual (Page 17)

Listening to Radio Broadcasts
Manual tuner operation (to tune to broadcasts by using the iog dial)
2 3 4
-MNIMiWAUOCA'noN
f---------1
1
Press the TUNER Input select button.
2
Press TUNING to select the MANUAL tuning
mode.
•Every time you press this button, MANUAL, PRESET and
(AUTO) modes alternately appear.
•AUTO will appear only when the FM mode is selected.
3
Press the band-select button to select FM,
MW, SW1 or SW2 (For Australia and New
Zealand, FM, LW, MW).
The display will show which band you selected.
Received band Received frequencies
Turn the Jog dial to tune In the desired broad­
cast.
The display will show the frequency to which you have tuned.
•If you have tuned in an FM stereo broadcast, the FM stereo
indicator will appear.
(For areas except for Australia and New Zealand only:)
•If you can't receive the desired MW broadcast, or can’t set
the frequency, you may need to adjust the “allocation"
setting. (See right.)
■ MW allocation settings
(For areas except for Australia and New Zealand only:)
This unit comes equipped with an electronic digital tuner that di­
vides the broadcast band into many smaii steps. These steps
match the assignable broadcast frequencies and intervals in
between.
Each country allocates (assigns) broadcast bands according to
their particular needs.
By adjusting the allocation, you can enable the tuner to receive MW
broadcasts allocated in 10 kHz steps.
1. Press the band-select button to select FM.
2. Frees and hold the band-aelect button for approximately
5 seconds.
The frequency display will be returned to the minimum
frequency of the MW band and the display will begin to
flash, continuing for approximately 5 more seconds.
3. When the display stops flashing and indlcales a dlffarent
frequency number, release the band-select button.
To return to the original frequency indication, repeat st^ 1 to 3
above.
Note;
After changing the allocation setting, the MW frequencies you pre­
viously preset to the memory will be cleared.
17