Preparations for infrared data communications, Infrared communication port, Problems with infrared data communications – Panasonic CF-25 User Manual

Page 21: Running tranxit, Running the program, Setting or changing the “computer name, Inf ràréd; bâta-cbm

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

r’'"”

t' “ • A’

j '.

.‘I

Inf ràréd; bâta-Cbm^

Your computer is equipped with an infrared coinmunications port enabling you to transfer data

without a cable

Preparations for Infrared Data Communications

• Set the address of your infrared communications port to enable
• Position your computer so that the port is faee-to-face with the port of another com­

puter

• Be sure the computers are not m di­

rect contact with one another

• A port-to-port distance of 20 to 50

cm

( 8

to

2 0

inches) is recommended

Infrared Communication Port

^ -v'

■ !+'

-T

"" y ’

* * - *

^.«In the Setup^Utility, sel^t [irDA] in'^l Supervisor Setup]^and set I Automatic {RnP)] or-/;
i ' [2F8]-^Setting [OFF;] will make infrared data communications' impossible"^ - -

_ . jr ll______ '

__ f /

^ t, ./ ... .

^

t*. *1 1

' ... - i, f

# Problems with infrared data communications

• An object is located between both ports
• There arc other electronic devices nearby causing mterierence such as a television,

VCR, wireless headphone etc

• Direct sunlight or white glowing light such as fluorescent lighting, can cause inter­

ference with communications between the ports

Running TranXit™

TranXit comes preinstalled and allows you to perform infrared data communications such

as the transfer ot data or the updating of information between two computers Note that both

computers need to have TranXit installed and running

# Running the program

Select [TranXit] from [Start] -
[Programs] - [TranXit]

X

note

>

Online help is available on how to use

TranXit Click [TranXit Quick Reference
Guide] in [Start] - [Programs] - [Panasonic)
nnstalling TranXit Q=* page 35)

y

Setting or changing the “Computer Name”

It IS necessary to assign a different Computer Name ’ to each computer select [Com­
puter Name] m

j

Setup] to change the name

• In [Control Panel] if [Infrared] is enabled, TianXit can not be used For TranXit to

be operable, [Inlrared] must be disabled

• Exit TranXit before entenng the suspend or hibernation mode" Start TranXit again

after the computer lesumes

^

‘ -

21

Advertising