Panasonic NV-G45 Series - Manual (Page 21)

Transmit the Programming Data
Keep pressing the Trasmit Button and confirm that the
programmed data on the Multi-Function Display of the VTR
are as desired.
After releasing the button, the data will continue to be
displayed for about 12 seconds.
•If the transmission was not received correctly, the
“Beep-Beep, Beep-Beep” sound from the VTR will warn
you. In this case, perform transmission again.
•The transmission is possible when the VTR is turned on
but is not in any of the recording or playback operation
modes. It is also possible when the VTR is in the timer
recording standby mode (H indication is lit).
•The programming will be done on the next lower unoccu­
pied timer programme number (7-1),
•If all programme numbers are occupied, the “Beep-Beep,
Beep-Beep” sound from the VTR will warn you that the
programming cannot be made.
•When the Transmit Button is pressed, the VTR will
automatically be put into the timer recording standby
condition and the VTR will be turned off.
•To operate the VTR before the timer recording will be
performed, press the Timer Rec. Button to suspend the
timer recording standby condition. After using the VTR, be
sure to press the Timer Rec. Button again, otherwise the
timer recording will not be made.
For Programming More than One Timer Recording in
Succession
Repeat the following operation steps 0
~
0
-
^ Trace the “CANCEL” bar code on the Programming
Sheet.
CANCEL
n 1 I IH
^ Trace the bar codes for “CHANNEL”, “DATE”,
“START TIME” and “END TIME”
o Confirm that the present time is displayed on the
Multi-Function Display of the VTR, and transmit the
data.
•If the next timer programming data are transmitted
while the previous timer programmming data are still
being displayed, the displayed timer recording data
will be cancelled.
For Everyday Recording
(T) Turn on the Digital Scanner and trace the "CHANNEL"
bar code.
@ Trace the “EVERYDAY” bar code.
EVERYDAY SUMOTUWETHfflSAON
T
1
B-
OFF
Trace the “START TIME” and then the “END TIME”
bar codes, and transmit the data to the VTR.
SU MO TU WE TH FR SA ON
0 * n n
U ' U U
OFF
f H - n n
IU‘UU
►Everyday recording will be performed from that day
on.
►If a “DATE” bar code is traced after tracing the
"EVERYDAY” bar code, everyday recording will not
be performed.
21