Panasonic NV-G45 Series User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
л
SYMPTOM
CAUSE
REMEDY
Playback picture is not in colour.
Playback picture has large
amounts of “snow”.
Reception channel was not adjusted
correctly during recording.
Readjust reception channel correctly.
TV set is not properly tuned to the video
playback channel of the VTR.
Properly tune the TV set to the video
playback channel of the VTR.
The video heads are clogged with dirt.
Consult qualified service personnel.
The video heads are abraded.
Consult qualified service personnel.
Tape is old and/or defective.
Use new tape.
Remote Controller (Digital
Scanner) does not work.
Remote Controller (Digital Scanner) is not
being pointed at Infra-red Receiver Window
on the VTR.
Point the Remote Controller (Digital Scanner)
at Infra-red Receiver Window on the VTR.
Distance is too far.
Use the Remote Controller (Digital Scanner)
within 7 m from the VTR.
An obstacle is between Remote Controller
(Digital Scanner) and VTR.
Remove obstacle.
Batteries are exhausted.
Replace batteries.
Battery polarities (-)-, -) are reversed.
Insert batteries correctly.
Bar code reading with Digital
Scanner is impossible.
The scanner is in the power-saving standby
condition.
Set the Digital Scanner On/Off Switch to
“OFF” and then to “ON" again.
The bar code has been traced too slowly.
Trace the bar code quickly.
The bar code was not traced all the way from
the Small Box past the last bar.
Trace the bar code correctly.
The bar code was not traced straight.
Trace the bar code straight from left to right.
Transmission from the Digital
Scanner to the VTR cannot be
performed.
The VTR is turned off.
Turn the VTR on.
The VTR is in an operation mode.
Put the VTR into the stop mode.
There is no unoccupied timer programme
number left.
A maximum of 8 timer recordings can be
programmed at the same time.
Reading a bar code was not followed by a
“beep” sound from the Digital Scanner.
Perform the bar code reading again.
The transmission was not followed by a
repeated “beep” sound from the VTR.
Keep pressing the Transmit Button until the
confirmation sound is heard.
27