Panasonic NV-G45 Series - Manual (Page 8)

INSTALLATION, TUNING THE TV SET TO THE VIDEO
PLAYBACK CHANNEL
1 1 ,s ; I ....................................... . ................... ..........................................
•NV-G45A:
FOR YOUR SAFETY
. Install any external aerial to AS 1417.1.^
* *i, # i. * T * » "L. 4S, i.
Video Playback Channel Selector
This switch is used to select the Video Playback channel
which is not occupied with any TV station. [NV-G45A: 0 or
1; NV-G45EA: 2 or 3].
Connection to a TV Set
O Connect the external aerial to the RF Input Socket on
the VTR.
@ Connect the aerial terminal on your TV set to the RF
Output Socket on the VTR with the supplied DIN-DIN
Coaxial Cable.
o Connect the AC Mains Lead to the AC Mains Socket of
the VTR to the mains outlet.
Video Playback Channel
O Turn the TV set on.
^ Press the VTR On/Off Switch to turn the VTR On.
(FRONT SIDE)
VTR
•The corresponding indicator lights up.
0 Set the VTR/TV Selector Switch to “VTR”.
(FRONTSIDE)
/■
VTR/TV
►VTR Mode Indicator will appear in the Multi-Function
Display.
RF Signal Level Switch:
Used to attenuate the reception of the VHF and/or UHF
aerial signals.
If the reception is normal, set to “HIGH”. If the signal is
strong (stripes appear in the upper part of the picture), set
to “LOW”.
Q Set the Test Signal Switch to “On”.
OFF' \T ]-ON
TEST
SIGNAL
Tune the selected programme position (channel) of the
TV set to the VHF channel shown below for your
model. Confirm on the TV set that the received test
pattern is as shown below.
NV-G45A VHF channel 0 or 1*
NV-G45EA VHF channel 2 or 3
NV-G45A only
’In some areas chan­
nel 0 may be used
by local TV station.
In this case switch to
channel 1.
^ Set the Test Signal Switch to “Off”. Your TV is now
ready to receive the RF output signal from the VTR.
OFF-[T] -ON
TEST
SIGNAL
0 To check, play back pre-recorded tape and readjust
Fine Tuning of TV if necessary.
8