Panasonic KX-P3123 - Manual (Page 37)

Feeding Paper
You can adjust the paper position by using the front panel switches when the printer is in the OFF
LINE mode or when the printer is not printing in the ON LINE mode.
Form Feed
With paper installed, pressing [ FF] moves the printhead to the center and advances the paper to the
next Top of Form (TOF) position.
Line Feed
With paper installed, pressing [ LF] once advances the paper one line. Holding the switch will move
the printhead to the center and advances the paper continuously until you release the switch.
Micro Line Feed
With paper installed, while pressing (ON LINE) , press [ FF] once to advance the paper one micro
line (1/180"). Holding the switch will advance the paper continuously until you release the switch.
Reverse Micro Line Feed
With paper installed, while pressing [ ON LINE ] , press (TQ once to reverse the paper one micro
line (1/180"). Holding the switch will reverse the paper continuously until you release the switch. The
printer cannot reverse the paper past the printable area, (
b ^ P. 93)
(D
Note:
• Reverse Micro Line Feed will not work correctly in the pull tractor mode.
• When pressing [ F F ] or (TQ , the amount of paper which is fed is determined by the current
setting for lines per inch (Ipi). The Ipi is specified by the software command or through the control
panel.
Tear Off (Rear Feeding Only)
This function allows you to advance your fanfold paper’s perforation to the tear position. This is not
dependent on your Top of Form (TOF) position, but is dependent on your form length. After tearing
off the page, you can return your paper to your Top of Form. This function can be automatic through
the FUNCTION mode.
1 Be sure the power is on. Note:
• Make sure the ON LINE/FUNCTION
indicator is not blinking. If it is blinking, press
[ FUNCTION i
37