Panasonic KX-P3123 - Manual (Page 64)

Using the Setup Disk
This setup disk can only be used in an IBM-PC or a compatibie computer with a 3.5"fioppy disk
drive.
Before you use the setup disk, it is recommended that you make a back-up copy and store the original
in a safe place.
This printer has been factory set to operate with most of the popuiar software packages, in
most cases there wiii be no need to change the initiai setup items. Refer to page 62 to verify
that the factory settings meet your requirements, if no changes are required, you shouid be
ready to print.
Note:
• Use the DISKCOPY command of the operating system to make a back-up copy. Refer to your
DOS manual for further information.
• You may find it convenient to install the Setup Disk programs directly onto your C Drive, rather
than reading them from the Setup Disk each time a change is necessary. Either method is
acceptable.
To perform an automatic installation of the Setup Disk files onto your C Drive, follow the steps
below:
u
CO
o
o
a
(D
1. Insert the Setup Disk into drive A or B.
2. Type A: (or B:) and press [ Enter].
3. Type INSTALL and press [Enter].
This procedure automatically creates a directory called 3123 and copies all of the programs
from your Setup Disk onto your C Drive.
At your C:\ >prompt, type CD 3123 and press [Ynter].
Type SETUP and press 1 Enter] to complete the procedure. Be sure to type this instruction as
one word.
if not, you will receive a Syntax error message.
64