Fax reception, Fax transmission – Panasonic KX-F900 User Manual

Page 57

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

PROBLEM

CAUSE & REMEDY

[LOCATOR/INTERCOM] does

not function

•The handset is too far from the mam unit or is engaged in an outside

call

The TALK/BATT LOW indicator
flashes slowly or the unit

beeps intermittently.

•Charge the battery fully or replace with a fully charged optional spare

battery (p 13,62)

You charged the battery fully,
but the TALK/BATT LOW
indicator flashes slowly

•Clean the charge contacts and charge again
• It

IS

time to replace the battery Please purchase a new battery (p 61)

The IN USE/CHARGE indicator

an^or the SPARE CHARGE
indicator light never goes out
while charging.

•This

IS

normal

Fax Transmission

PROBLEM

CAUSE & REMEDY

The other party complains that

letters on their received

document are distorted

• If your line has special telephone services such as call waiting, the

service may have been activated during fax transmission Connect the

unit to a line that does not have such services

•An extension telephone on the same line is off the hook Hang up and

try again

The other party complains that
dirty patterns or black lines
appear on their received
documents

•The glass or rollers are dirty Clean them (see page 63)

I cannot make an international

fax call.

•Use the overseas transmission mode (see page 40)
•Add two pauses at the end of the phone number (see page 37)

Fax Reception

PROBLEM

CAUSE & REMEDY

I cannot receive documents

automatically.

•The receive mode is set to the TEL mode Set to the EXT TAM,

TEL/FAX or FAX mode

•The time to answer the call may be too tong Decrease the number of

rings (see pages 25 and 27)

•The junk mail prohibitor is set to on (see page 42)

The recording image is faint.

•The sender transmitted a faint document Request them to transmit a

clearer copy of the document

The received document is

blank

•The recording paper roll is installed incorrectly Make sure that the shiny

side of the paper is facing down and re-install the paper (see page 10)

57

Advertising