Panasonic KX-F900 - Manual (Page 58)

Operation in EXT. TAM mode
PROBLEM CAUSE & REMEDY
1 cannot receive documents
automatically.
•Your greeting message is too long. Shorten it (up to 10 seconds).
•There are too many rings on the answering machine. Set the number of
rings to less than 4.
•The silent detection feature is deactivated. Activate this feature (see
page 49).
1 cannot receive voice
messages. •Check that the answering machine is turned on and connected to the
facsimile unit properly {see page 46).
•Set the number of rings on the answering machine to less than 4.
1 cannot retrieve voice
messages on the answering
machine from a remote
location.
•The remote access code on your answering machine is the same as the
remote fax activation code or the junk mail prohibitor ID on the facsimile
unit. Set a different number for each code/ID.
•Your remote TAM activation code is not programmed correctly. Program
the same code as on the answering machine (see page 48).
The greeting message on your
answering machine is
interrupted halfway and the
caller cannot leave a voice
message.
• Silent pause in the greeting message is too long. Shorten it to less than
4 seconds.
1 pressed the remote access
code to access the answering
machine remotely, but the line
was disconnected.
•The code may include “#" which is used for certain features provided by
the telephone company. Change the code on the answering machine
not to include “#”. Then program the same code into the facsimile unit
(see page 48).
Copying
PROBLEM CAUSE & REMEDY
A dirty pattern or a black line
appears on the copied
documents. •The glass or rollers are dirty. Clean them (see page 63).
The copied document is blank. •The recording paper roll is installed incorrectly. Make sure that the shiny
side of the paper is facing down and re-install the paper (see page 10).
If a power failure occurs
•This unit does not function during a power failure.
•The memory contents will not be erased.
• If the programmed start time has passed during a power failure, delayed transmission will be attempted after
power is restored.
58