Tuning the tv to your vcr, Operations, Turn on the tv and the vcr – Panasonic NV-HD630 User Manual
Page 10: Press menu
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Tuning the TV to your VCR
1,2
The VCR supplies a signal to the TV via the RF coaxial
cable on channel AU28-69, or NZ21-69.
It is possible to view the video picture on your TV in the
same way that you watch TV broadcasts.
If you have connected the VCR to the TV through the video
and audio input sockets, then you do not need to follow the
procedure below.
When the VCR is turned on after unpacking and
connecting the aerial cable and the mains lead, Plug in
Auto Tuning starts automatically.
(NV-HD630EA only)
Notes:
• If the VCR is turned on with the aerial not connected, all
channels are skipped. Therefore, firmly connect the aerial
and then turn the VCR off and on again to execute Auto
Tuning.
Operations
1
When Auto Tuning is cancelled halfway. Auto Tuning is not
executed even if the VCR is turned off and then turned on
again. In this case, see page 12 “To restart Plug in Auto
Tuning”. (NV-HD630EAonly)
POWER
@
Turn on the TV and the VCR.
For NV-HD630A
For NV-HD630EA
On Screen Display
AUTOTUNMG
AUTOTUNMQS
M PROGRESS,
COMPLETED.
PLEASE WAIT.
(During Plug in Auto Tuning) (After Plug in Auto Tuning)
Set the TV to an unused position which
you
wish to use for your video playback.
For NV-HD630A
•Tune the TV until the TV programme screen appears.
(Please refer to the TV manufacturers operating
instructions regarding tuning.)
For NV-HD630EA
•Tune the TV until the display shown on the left appears on
the screen. (Please refer to the TV manufacturers
operating instructions regarding tuning.)
Press MENU.
•This operation is not necessary for NV-HD630A.
JO