G-code programming, Preparations, Operations – Panasonic NV-HD630 User Manual
Page 32: On screen dispiay and dispiay symbol, Press g-code, Enter a g-code number, Press enter, Press timer rec, Ia a a, S @ s i
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
G-Code Programming
Programming is now easier than ever; simply enter the G-
Code number found in the programme scheduling pages of
newspapers and magazines.
G-Code numbers are numbers assigned to programmes
listed in the TV programme schedule found in newspapers
and TV guides. When these numbers are entered, the
numbers are converted to actual programming.
Preparations
• Insert a video cassette tape with an intact erasure
prevention tab.
• Confirm that the TV is on and the VCR viewing channel is
selected.
• Turn on the VCR.
• Check that the clock is set to the correct time. If it has not
been set, refer to page 18.
Set VCR—TV switch to VCR for using the
numeric buttons and the G-CODE button.
Operations
On Screen Dispiay
and Dispiay Symbol
1
Press G-CODE.
• Ensure that VCR—TV switch
is set to VCR.
G - C O D E
a
Enter a G-Code number.
Example:123456
»It is also possible to check
the number with VCR display
without appearing the On
Screen Display.
»If you have entered the wrong number, press
CANCEL then enter the proper number. An
alternative method is to press < and then enter the
proper number.
i ? 3 H 5 b - - -
Press ENTER.
•The entered programme
appears on the display.
•The starting time and the
ending time appears
alternately each 5 seconds
on the VCR display.
3D n i D u i :
L J I !
1 J I 3
»Confirm that the number
corresponds to the right
programme. If the display
looks like this and □ on the
VCR display flashes on and
off: select the programme
position of your VCR which
receives the TV station you
entered at step 2 using the
O
(CH) then press ENTER.
CH DATE ON OFF
23 17M0 13:4$ 14:15 SF
S @ S i
OFF SP
3 3
n
lu- tc
L J
I I
M i l
CH DATE ON OFF
— 17M0 13:45 14:15 SP
-:|ia a a
•To make any corrections, use buttons 0 (DATE), O
(ON) and O (OFF) the same way as described on
page 29.
Press TIMER REC □.
TIMER REC
rm
Notes:
• To select the desired tape speed, press SPEED after step
3.
• When the G-Code number is used for programming, the
recording time may be slightly longer than the actual
programme time.
• Repeat steps 2 and 3 if “PROGRAMME IS
INCOMPLETE.” appears.
• When programming two or more programmes, repeat
steps 1-4.
• The procedures for checking and cancelling a timer
programme are the same as on page 31.
32