Press [■, tune mode] to select “manual, Press and hold memory] until the, Presetting radio broadcasts – Panasonic SC-AK18 EN User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Presetting radio broadcasts
up
to 12 stations can be set in each band with the automatic or
manual memory presetting.
If broadcast frequencies are preset in the memory, you can easily
tune in any of these frequencies from the system or remote control
unit.
You can preset just those stations you like. (See “Presetting only
your favorite stations" below.)
1
Press [TUNER, BAND] to select band.
The system will come on automatically.
Every time you press the button: FM <-> AM
Press [■, TUNE MODE] to select “MANUAL".
Every time you press the button: MANUAL PRESET.
Press [TUNE/TIME ADJ (V) or (A)] until the display
shows the frequency from which you want to begin
automatic memory presetting.
Tips on tuning in radio stations
® Hold down either arrow button until the frequency numbers
start scrolling.
d) When near to the frequency you are looking for, press the
button repeatedly until the station is tuned in.
Press and hold
MEMORY] until the
frequency begins to change.
This will start presetting automatically. When finished, the radio
will tune in the last station memorized.
If auto presetting is not possible because radio signals are weak
or for some other reasons, do the following.
Presetting only your favorite stations
Preset the stations one at a time.
1. Perform step Q above. Then, press [►►/►►!, MEMORY]
("MEMO” flashes) and select a station with [TUNE/TIME ADJ
(V) or (A)].
2. While “MEMO” is flashing, press
(►►/►►I,
MEMORY] again and
select a preset channel with [TUNE/TIME ADJ (V) or (A)].
3. Press fpV/^W, MEMORY] to preset the station.
Memory retention
Your preset is retained in memory for about 2 weeks while the system
is unplugged.
FM allocation setting
By adjusting the allocation, you can enable this tuner to receive FM
broadcasts allocated in 0.1 MHz steps.
Press and hold [TUNER, BAND]. After a few seconds, the display will
change to a Hashing display of the current minimum FM frequency.
If you continue to hold the button down, the minimum frequency will
change. Release the button at this time.
To return to the original frequency indication, repeat above.
After changing the “allocation” setting, the frequencies you previously
preset in the memory will be cleared.
RQT5258