Press [tuner, band] to select band, Press p, tune mode] to select “preset” or “manual, Adjust the volume level – Panasonic SC-AK18 EN User Manual
Page 13: Listening to radio broadcasts
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
"5
\
)“t )”l l~ r (-------- r
I”
J"' C "I C
'
)i/( l”( Ji ( 1
\r\\
I I l”l t 't
u M t_
I
jwt
(“I O ‘
I
j
r (
u J_(. (
) - n )
\ \ r \ \ - \
1'
U
l_
1 U U J.I
Listening to radio broadcasts
Press [TUNER, BAND] to select band.
The unit will come on automatically.
Press p, TUNE MODE] to select “PRESET” or
“MANUAL”.
Every time you press the button: MANUAL
<r->
PRESET.
PRESET: For preset stations
MANUAL: For non-preset stations
Press UUNEA'IME ADJ (V) or (A)] to select the
desired broadcast.
“STERECT lights when an FM stereo broadcast is being received.
TUNECr lights when you precisely tune in a broadcast station.
Adjust the volume level.
Auto tuning
Auto tuning is an easy way to tune in non-preset stations in the
manual mode.
Hold down either [TUNE/nME ADJ (V) or (A)], and release the
button when the frequency starts scrolling.
The frequency will stop scrolling automatically on the first station it
picks up.
• When there is outside interference, the radio sometimes stops on
a certain frequency where no station is broadcasting.
To stop auto tuning
Press either UUNE/TIME ADJ (V) or (A)] again.
If noise is excessive in the FM stereo mode Q
Press
FM MODE/BP]. (“MONO” will light up.)
Sound will be produced in monaural, but this also reduces noise.
Press the button again to cancel. “MONO" will go out.
Normally, you’ll want to listen in stereo, so leave “MONO” off. This
way, you can listen to stereo broadcasts in stereo, and monaural
broadcasts in mono.
You can preset an FM station in monaural by following the steps
under “Presetting only your favorite stations” on page 12. After selecting
the station in step 1, select “MONO" with
FM MODE/BP],
then continue with steps 2 and 3.
If you preset stations in memory they can be easily selected from
the remote control with [-^/V], [►/!!/A] or the numeric buttons.
1. Press [TUNER] to select the band.
2. Press [“^/V] or [►/ll/A] to select the channel, or select the
required channel directly with the numeric buttons.
To select a two-digit channel:
Press [S10] and then the two numbers you want within 10
seconds or so.
Sound is momentarily interrupted if you load/unload tapes while
listening to an AM broadcast.
W)
I
I
.0
■O
&
RQT5258