Panasonic OMNIVISION PV-HD1000 - Manual (Page 23)

VCR Plus+ System Programming
Check list before you begin.
□ The clock is set.
Q VCR Plus+ Setup is complete {see page 22).
Inm- |l| M
fa O O Ì
Multi Function Display
Use normal Timer Recording steps if;
• the PlusCode for a program is not listed.
• you anticipate the program, such as a sporting
event, to run over the scheduled stop time.
See page 21 to:
• cancel a timer recording in progress,
• replace program contents.
• review or clear program contents once set.
Important notes when using a DSS receiver
• When recording programs via a DSS receiver,
the DSS receiver must be left on.
• When recording programs via an antenna or
cable, the DSS receiver must be turned off.
1
Press PROG to display the
“SET PROGRAM" screen.
2
Press AW to select “VCR Ptus+
PROGRAM,” and then press ►
to display the “VCR Plus+” screen.
---------SET PROGRAM-------------
VCR Plusf PROGRAM
TIMER PROGRAM
VCR P(us+
ENTER PLUSCODE NUMBER
USING 0-9 KEYS
END :PROG KEY
3
Press the NUMBERED keys to
enter the PlusCode number.
• Refer to your local TV listings.
To Make Corrections
Press ^ repeatedly to delete the
PlusCode number. Then, enter the correct number.
VCR Plus+
ENTER PLUSCODE NUMBER
123456
USING 0-9 KEYS
BACKSPACE:4 KEY
ENTER iPROG KEY
Press PROG to lock in your program.
5
Press the 1, 2 or 3 key to select
the program type.
6 Press AW and ► to select and
set each of the remaining items
as follows.
Remaining Items
• Speed (SP, LP. SLP)
To Make Corrections
Repeatedly press ► to move the cursor
to the right, or to move to the left to the
incorrect entry and make the correction.
1 ONE TIME
2 DAILY(MON-FRI)
3 WEEKLY
START S
TODAY
SELECT:* Y KEY
SET
► KEY
END :PR0G KEY
If you use connection type “A"
on page 10, the channel shown
in this on-screen d;splay will
always be the cable box output
channel number.
7
Press PROG if contents are
acceptable.
To cancel program contents:
Press ADD/DLT.
P DT START STOP CH SPD
1DAY 9:OOA12:OOA 08 SP
3---------- ;--------- __ __
CANCEL:ADD/DLT KEY
SELECT 1-0:* ¥ KEY
ENTER ;► KEY
END :PROG KEY
8
Press PROG to complete
the program.
• If you’re using a Cable Box, make sure
that it is tuned to the desired channel
and the power is left on for timer
recording.
TURN VCR OFF FOR TIMER
RECORDING AND LEAVE
CABLE BOX POWER ON
' This display may differ depending
on your cabie box hook-up.
Press POWER off to set the timer.
Multi Function Display
Digital programs cannot be programmed with VCR Plus+ because PlusCodes are not available.
You can obtain unlisted PlusCode numbers by calling 1 - 900 - 454 - 7587, Call costs approximately $.95
per minute.
VCR PlusCodes can not be used to program the D-VHS VCR to record DSS channels.
Avoid overlapping program times.
An on-screen display will indicate if an invalid PlusCode number has been entered or when all timer
programs are full.
23