Panasonic CW-1773SR - Manual (Page 6)

CW-1773SR (Cooling And Heating)
1. Power Supply
Set the Main Control Knob to the OFF
position; confirm that the Power Supply
Cord is connected to a proper AC outlet.
Recommended
Use the air conditioner
under the following
conditions:
When humidity does not exceed 90% and
room temperature is above 21 °C.
Continuous operation at over 90% humidity
may create condensation and waterdrops on
the intake and outiet vents.
2
. Open the
cover.
3
. Main Control Knob
Set to either LOW COOL, HIGH COOL,
LOW HEAT or HIGH HEAT.(Fan permits
fan operation without cooling or heating)
* Caution: if the Main Control Knob is turned off
or turned to a fan only setting from a cooling
operation setting, WAIT at least 3 minutes
before resetting to a cooling or heating
operation.
4
. Thermostat Control Knob
Set the Thermostat Control Knob to the desired
setting. (Usually “4 - 5” is a recommended
setting for heating, and "6 - 7” for cooling.) If the
room temperature is unsatisfactory after a
reasonable amount of time, turn the control
knob anticlockwise to make the room warmer,
or clockwise to make the room cooler.
• When the Thermostat Control Knob is set to
“10", moisture may freeze onto the coils and
prevent effective cooling. If this happens, turn
the Main Control Knob to Fan, and the
Thermostat Control Knob anticlockwise.
This will quickly defrost the cooling coil and
allow normal cooling.
5
. Air Swing Switch
(Airflow direction adjustment
Side-to-Side)
For fixed side-to-side air direction, set the Air
Swing Switch to “ON” until the desired air
direction is obtained, then move it to “OFF”.
For continuous side-to-side air circulation, set
the Air Swing Switch to “ON” and leave it there.
- 5 -