O recall, Ì© video level, Language selection – Panasonic PANASYNC TX-D7F21 User Manual

Page 16: Llg osd position, Degauss, S signal

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

<

On-Screen Display>

<

Function and Operation>

O Recall

To return to the initial settings (the settings at the
time of factory shipment).

1) When the lU key (Yes) is pressed, the settings

are recalled and the menu screen returns.

(Recall

=

return to settings at time of factory

shipment.)

2) When the [U key (No) is pressed, the menu

screen returns without the settings being

recalled (the settings return to what they were
immediately before the recall).

*

If no operations are performed for about 30

seconds, the screen goes off without recall.

R e c a l l

O K ?

[H;

Y e s N O :

[D

¡Ì© Video Level

The video input signal level can be matched to
the computer being used. Either 0.7V or 1,0V
can be selected with the [U key.

Note

:

0.7V is typical.

V i d e o L e v e l

0 . 7 V

0.7/1 V ; [5]

(If wrong level is selected image may be too dim

or too bright.)

7ii-

Language selection

The language used by the On-Screen Display
can be selected with the “H” and “B" keys from
among French, English, and Spanish.

FRA

;

French

ENG: English
ESP

:

Spanish

L a n g u a g e

FRA lagra ESP

llg OSD Position

It is possible to adjust the position that the On-

Screen Display is to be shown in.

The On-Screen Display will rotate in a counter­

clockwise direction every time the [D key is

pressed.

Degauss

(Demagnetise(See Trouble Shooting Page 17 Third Symptom.))

Degaussing operation can be selected. Use this control if display color is abnormal.

After this is selected, the degaussing action takes place for approximately 6 seconds.

Key operation is not possible while demagnetization is performed.

S Signal

Resolution (1024 x 768) will only appear if the

video signal is a preset or reservation timing

(See page 15).

Signal displays the computer’s approximate

horizontal sync frequency (fH) and vertical

sync frequency (fV).

If the fH or fV are outside the specified range

then the Monitor Self Test function will auto­

matically display the Signal Error menu (See
page 9, Monitor Self Test, 2).

1 0 2 4 X 7 6 8

f H 6 0 . 2 k H z

f V 7 4 . 8 H z

- 1 2 -

Advertising