Panasonic PANASYNC TX-D7F21 - Manual (Page 9)

Installation
^Connecting Procedures
Turn off your computer.
Connect the signal connectors as shown below.
Turn the monitor on, then turn on the computer,
A. IBM PS/2 or compatible models
Rear view
15'pin mini
D-Sub cable
(D
Connect the supplied signal cable to the monitor’s port.
(2) Connect the AC Power cord to the monitor CE22 connector on the rear of the monitor.
(D
Connect the other end of the AC Power cord to a grounded power outlet.
B. Apple computer
Use a UNIMAC-82D MAC adapter.
Panasonic MAC adapter
If you need an adapter and one Is not provided by your dealer,
call 1-000 PANASYS (1-800-726-2797).
u" *
(D
yd DDD
IDI 0- “3* 9
^ MAC adapter
r—Caution:----------------------------
To prevent the cable from coming loose,
the cable connectors must be securely
fastened with screws.
^Connection of AC Power Supply
------ Precaution: -----------------------------
• In order to use the display unit safely, use a power cord that is properly grounded.
• AC Power cord for the following countries are supplied in the same package.
U.S.A.........UL
Canada......CSA
For use in other countries, make sure the AC Power cord meets the safety standards of each country.
- 5 -